how to fix a ceiling fan

Download Article

If a drywall ceiling in your home has developed a crack, you can fix it relatively easily. Begin by laying down plastic and scraping away any loose paper or debris from the drywall, and then apply a single piece of mesh drywall tape over the crack. Cover the tape with 2 layers of 5-minute mud, sanding after each layer, and then paint the patched crack. This project should take about 30 minutes (not including 1 hour of drying time).

1
Put a sheet of plastic down under the crack. Since you'll be loosening debris, applying mud, and generally making a mess while you're repairing your ceiling crack, it's smart to put down a large sheet of plastic beforehand. This way, once you're done fixing the crack, you can just throw away the sheet of plastic and not have to worry about cleaning your floors.
- You can also remove cloth or fabric-covered furniture from the room since it will be difficult to clean paint and dust off of it.
2
Set up an A-frame ladder. An A-frame will provide stability as you stand on it to reach your ceiling. Make sure that all four legs are stable and flat on the floor before you climb up, and avoid making sudden movements while you're on the ladder. If your ladder has a fold-out section across from the top rung, you can use this to hold your tape, mud, and other repair supplies.^[1]
- A-frame ladders should be available for purchase at a local hardware store or home-supply store. A 6- or 8-foot (1.8-2.4 m) ladder will be most useful.
- If you have a low ceiling, you could feasibly use a step-ladder to fix the crack. The disadvantage, though, would be that you'll be more precariously balanced on top of the step-ladder, and won't have a way to set your patching materials within reach.
Advertisement
3
Scrape away loose material with a drywall knife. Position your 6-inch (15 cm) drywall knife at about a 15° angle against the ceiling near the crack. Slide it up under any loose, unattached pieces of drywall paper that are torn near the crack. Use the knife to slice these off, being careful not to damage the drywall beneath.^[2]
- Drywall knives will be available at any hardware store, paint shop, or home-supply store. Many sizes will be available, although the 6-inch (15 cm) is typically most effective.
4
Apply mesh drywall tape directly over the crack. This tape will be adhesive, so it will stick firmly to your ceiling. Use long strips of tape to cover the entire crack. In fact, depending on the length of the crack, you may be able to cover the entire thing using one strip of tape. Position the tape so it's centered directly over the crack, and press it firmly onto the ceiling.^[3] Do not apply more than a single layer of tape.
- Go over the tape a few times with a rolling pin or can to smooth it out.
- This is the same tape you use to connect the seams when you're installing drywall in the first place.^[4] It's available for purchase at a local hardware store or home-supply store.
- If the store has a variety of tapes, make sure to purchase an adhesive version.
Advertisement

1
Mix 5-minute mud powered with water. Shake out about 1 lb (0.45 kg) worth of dry mud into a large plastic container. Add lukewarm water from your kitchen tap. While holding the container over your kitchen sink, use your putty knife to thoroughly mix the 5-minute mud. Continue adding water and mixing until the mud is roughly the consistency of mayonnaise.^[5]
- You can also secure the ceiling crack with joint compound. However, 5-minute mud will set more firmly than joint compound, and bolster the structural integrity of ceiling drywall.
- Five-minute mud will be available for purchase at your local hardware or home-supply store. You should only need a 3-lb (1.4 kg) bag of the sand. This should sell for between $5 USD and $7 USD.
- You can also use mud with a longer drying time, like 20-minute mud. Using mud with a longer drying time will give you more time to do the repair. As long as you do not mix the mud too watery, it will not fall on you, but you will need more time at the beginning to get the hang of plastering a ceiling.
- Spray the ceiling with a spray water bottle to help the mud adhere to the existing plaster. Mud does not stick to dust, oil, mold, too flat or loose surfaces.
2
Apply a layer of the mud to your ceiling crack. Using the broad edge of your putty knife, apply a single, smooth layer of mud. Make sure to completely cover the mesh tape with mud. If you can, apply the mud in a single direction, parallel with the crack. Work quickly, since the mud will be dry in 5 minutes.^[6]
- Once you've applied the first layer, wait 30 minutes for the mud to fully dry.
- If the layer of mud looks uneven, use a wet sponge to smooth it out before it dries.
3
Add texture to the mud if your ceiling is texturized. Texturizing the mud will help it blend in with the rest of the ceiling. The best way to add texture to the mud depends on what kind of ceiling you have.
- If your ceiling has a swirl texture, use a soft paintbrush to recreate the pattern in the mud.
- If your ceiling has a knock-down texture, press a firm, wet piece of paper into the mud to replicate the texture.
- If your ceiling has a popcorn texture, spray over the mud with a popcorn ceiling patch spray.
4

Sand the first layer of mud once it's dried. Sanding the mud in between layers will help make the final result look smoother and more professional. Use a sanding sponge to gently sand any rough patches on the mud, working in a back-and-forth motion.
5
Mix a second batch of 5-minute mud. The second coat should be thinner than the first, so be sure to add more water from your kitchen tap to the same amount of sand. The thinner coat will cover any cracks or lumps present in the first coat of mud. Mix this batch until it's roughly the consistency of sour cream.^[7]
- Use the corners and edge of your putty knife to scrape out any pockets of dry sand from the corners or edges of the plastic mixing container.
6
Apply a second coat of the mud. Use the same technique that you used for the first coat. Fully cover the mesh tape with the mud. This layer should cover up the tape's grid pattern, so it won't be visible after you've sanded and painted the ceiling.^[8]
- As with the first coat of mud, you'll need to wait 30 minutes for this layer to fully dry. It should be dry in 5 minutes, but it's best to give it extra time to ensure it is fully dry and ready for paint.
Advertisement

1
Sand the layers of mud with a sanding sponge. Now that the crack is structurally repaired, you'll need to smooth out the rough patches. Take the sanding sponge and run it over the area you've covered with mud. Sand using a back-and-forth motion until the dried mud covering the former cracked area is smooth and flush with the rest of your ceiling.^[9]
- Sanding sponges can be purchased at your local hardware store. If they come in a range of grits, opt for a fine-grit sanding sponge.
- Depending on how much dried mud you sand off, it may make quite a mess. Try to ensure that the majority falls on the plastic sheet that you've laid down. If you still have fabric-covered furniture in the room, consider putting drop cloths over them to avoid permanent damage.
- If you are trying to match a very flat surface, mix the last coat of mud a little more watery than the first 2 coats and apply it to the ceiling with a 14 or 18 inch trowel. The longer trowel will fill in the low spots making a flatter surface.
2
Find a paint color that matches your ceiling. The portion of ceiling that you've patched and sanded will need to be painted to match the rest of the ceiling. If you have some paint leftover from when you (or contractors) painted your ceiling initially, you can use this to paint over the repaired crack.
- If you don't have leftover paint, you'll need to visit a paint shop or home-supply store to find a matching coat of paint. Larger hardware stores may stock and mix paint, also.
- Pick up several paint-color strips, and compare each color against your ceiling to find the closest match.^[10]
- You can also bring a sample of the paint to your local home improvement center or paint store and have them match the color for you using a computer.
3
Paint the portion of the ceiling that you've sanded. Once you have your paint, pour about ½ cup (113 grams) into a metal painter's tray. Roll your roller brush up and down through the paint until the entire surface of the brush is coated with paint. Then, working from one end of the patched crack to the other, use the brush to apply paint a layer of paint to your ceiling.^[11]
- After you've finished painting and the paint has dried, your ceiling should be a single color and texture.
Advertisement

Add New Question

Question

How do I fix a crack in the ceiling?

Andrew Peters is an Architecture and Construction Specialist and a Principal at Peters Design-Build, a full service architecture and construction firm in the San Francisco Bay Area. With over 20 years of experience, Andrew specializes in sustainable and holistic design and building practices. Andrew holds a Bachelor of Architecture and a Project Management Professional (PMP) certification and is a Leadership in Energy and Environmental Design (LEED)-Accredited Professional. He served as Project Manager for the international-award-winning "Refract House," Team California's entry in the 2009 U.S. Department of Energy Solar Decathlon, a project featured in over 600 online and print articles.

Architecture & Construction Specialist

Expert Answer

Support wikiHow by unlocking this expert answer.

Cover the crack with fiberglass mesh tape—the same drywall tape you use to connect the seams when you install drywall. Then, mud over that with drywall mud and finish it out like a typical drywall seam.
Question

What causes cracks in a ceiling?

Andrew Peters is an Architecture and Construction Specialist and a Principal at Peters Design-Build, a full service architecture and construction firm in the San Francisco Bay Area. With over 20 years of experience, Andrew specializes in sustainable and holistic design and building practices. Andrew holds a Bachelor of Architecture and a Project Management Professional (PMP) certification and is a Leadership in Energy and Environmental Design (LEED)-Accredited Professional. He served as Project Manager for the international-award-winning "Refract House," Team California's entry in the 2009 U.S. Department of Energy Solar Decathlon, a project featured in over 600 online and print articles.

Architecture & Construction Specialist

Expert Answer

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Although it's tempting, do not just apply spackling or joint compound over a crack in ceiling drywall. This cosmetic fix may hold for a while, but after a couple months, the crack will re-emerge, likely bigger than before.^[12]
Keep in mind that cracks in drywall typically appear due to movement in the house over time. Even if you fix it, chances are that the cracks will reappear eventually.^[13]

If you're concerned about getting dust in your eyes or inhaling it while you're sanding away the dried mud, wear a pair of protective eye goggles. You can also wear a surgery mask, or tie a bandana over your mouth.^[14] Both of these materials will be available at a local hardware store.

Things You'll Need

A-frame ladder
Self- adhesive mesh drywall tape
6-inch (15 cm) drywall knife
Easy Sand 5-minute mud
Plastic bucket or mixing container
Sanding sponge
Surgery mask (optional)
Protective eyewear (optional)
Paint that matches the color of your ceiling
Roller brush

About This Article

Article SummaryX

To fix a ceiling crack, start by scraping away any loose material from the crack with a drywall knife. Next, put mesh drywall tape over the crack and press it firmly onto the ceiling. Then, prepare 5-minute mud by mixing the mud powder with lukewarm water. Once the mud is mixed, apply a layer of it to the ceiling using a putty knife, making sure to completely cover the drywall tape. Finally, allow the mud 30 minutes to dry before sanding it down and applying a second coat of mud. For tips from our Handyman reviewer on how to paint over your repair so it matches the rest of the ceiling, read on!

Did this summary help you?

Thanks to all authors for creating a page that has been read 85,009 times.